I started by making a rectangle
I extruded the rectangle so I could cut out parts into it
I started to make paths in the rectangle and extrude them
This was my final piece before putting it into fusion 360
After designing my maze in fusion 360, I used the router to cut it out.
After I Routed my maze, I used the laser to engrave my name and this was my final piece.
Conclusion
I had a lot of fun using the router. This station went a lot easier than the others because I felt like I knew how to use it better than the other machines. My maze turned out perfectly and I was excited to use the router.
I had a lot of fun using the router. This station went a lot easier than the others because I felt like I knew how to use it better than the other machines. My maze turned out perfectly and I was excited to use the router.